Lieferzeit ca. 14-21 Werktage. 3 Stk. im Lager USA
Auf Lager
Kaliber: 223 WSSM (Winchester Super Short Mag), 243 WSSM (Winchester Super Short Mag), 270 WSM (Winchester Short Mag), 7 mm Remington Magnum, 257 Weatherby Magnum, 264 Winchester, 6.5 mm Remington Magnum, 270 Weatherby MagnumStyle: Press Type
734307905224 Universal-Hülsenhalter, der in den meisten Marken von Wiederladepressen verwendet wird. Funktioniert nicht mit Lee Auto Prime. Siehe Lee Hülsenhalter-Diagramm
Auf Lager
Lieferzeit ca. 14-21 Werktage. 3 Stk. im Lager USA
Lieferzeit ca. 14-21 Werktage. 3 Stk. im Lager USA
Lieferzeit ca. 14-21 Werktage. 3 Stk. im Lager USA
Auf Lager
Kaliber: 223 WSSM (Winchester Super Short Mag), 243 WSSM (Winchester Super Short Mag), 270 WSM (Winchester Short Mag), 7 mm Remington Magnum, 257 Weatherby Magnum, 264 Winchester, 6.5 mm Remington Magnum, 270 Weatherby MagnumStyle: Press Type
Universal shell holder used in most brands of reloading presses. Will not work with Lee Auto Prime. View Lee Shellholder Chart
Universal-Hülsenhalter, der in den meisten Marken von Wiederladepressen verwendet wird. Funktioniert nicht mit Lee Auto Prime. Siehe Lee Hülsenhalter-Diagramm
Eigenschaften
Kaliber:223 WSSM (Winchester Super Short Mag),243 WSSM (Winchester Super Short Mag),257 Weatherby Magnum,264 Winchester,6.5 mm Remington Magnum,270 Weatherby Magnum,270 WSM (Winchester Short Mag),7 mm Remington Magnum
Style:Press Type
Versandgewicht:0,159kg
Versandhöhe:1mm
Versandbreite:94mm
Versandlänge:127mm
UPC
:734307905224
Kundenbewertungen
Kundenbewertungen (1)
4 / 5
Empfehlenswert
Modified for Sinclair priming tool 13.12.2017
The Sinclair priming tool is in my opinion the best for accurately and consistently seating primers. However, for .338 LM (based on .416 Rigby) there are not a lot of options. The proper Sinclair holder is backordered from Brownell.
However the Sinclair tool accepts Lee hand priming tool shell holders and the #8 Lee shell holder fits and can be installed into the Sinclair tool by facing off the lug that holds the shell holder into a press thus converting it to a Lee priming-type shell holder, in other words just make this holder flat across the bottom as are the Lee priming shell holders. I did this easily in the lathe, a 5 minute job.
You may also need to modify the primer cup in the Sinclair tool to allow a case to fit smoothly. I took .025 off the lip of the cup to match the shell holder floor. The Sinclair plunger is adjustable (see their directions) and it sets primers just below flush when is set to .010 above the lip of the primer cup.