Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fit: Ruger Flattop Revolvers
Entferne einfach die hintere Visierung deiner Waffe und ersetze sie durch die EGW-Montage, um dein Vortex Viper/Venom, Burris FastFire oder Docter Rotpunktvisier zu montieren. Du kannst die Montage jederzeit abnehmen und deine hintere Visierung wieder anbringen. Montagematerial ist enthalten. Installationsanleitung: Entferne die hintere Visierung* Installiere die EGW Sichtmontage in der Nut Ziehe die Schraube fest (sofern zutreffend) Platziere das Rotpunktvisier auf der EGW Sichtmontage (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Sichtmontage erleichtert die Entfernung und hält Loctite vom Rotpunktvisier fern.) Trage blauen Loctite auf die bereitgestellten Montageschrauben auf. Ziehe die Montageschrauben mit 15in/lbs fest. 2 Button Head Cap Screws - Bereitgestellt für Vortex Viper und Venom Visierungen. 2 Flat Head Cap Screws - Bereitgestellt für Burris FastFire und Docter Visierungen. Die mit dieser Montage gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel zur Installation. Diese Montage passt nicht auf: Ruger Flattop Revolver.