R2S FLASH HIDERS These fit Plan B type mounts. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 15-25 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH Atlas and Atlas XL compatible Plan B compatible Black Nitride finish (67 HRC Surface hardness) Shims not included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.
R2S FLASH HIDERS Diese passen auf Plan B Montagen. Verwende immer eine Ausrichtungsstange, um sicherzustellen, dass das gesamte System korrekt eingerichtet ist. Stelle sicher, dass alle Oberflächen gereinigt sind und das Mündungsgerät fest mit dem Lauf verbunden ist. Die Verwendung an einem Q-Dämpfer kann deine Garantie ungültig machen, sei gewarnt. Ziehe das Mündungsgerät auf etwa 15-25 ft lbs an. Stelle sicher, dass das Mündungsgerät rechtwinklig zur Schulter sitzt. Beim Anbringen des Schalldämpfers auf dem Mündungsgerät, achte darauf, dass die Gewinde und Konen sauber sind. Ziehe den Schalldämpfer auf 10 ft lbs an. Achte auf die Ausrichtung. Viel Spaß. Die Nitride-Beschichtung sorgt für eine bessere Abdichtung, daher ist es äußerst wichtig, dein Mündungsgerät richtig am Lauf anzuziehen und zu sichern. MERKMALE: 17-4 PH Atlas und Atlas XL kompatibel Plan B kompatibel Schwarze Nitride-Oberfläche (67 HRC Oberflächenhärte) Unterlegscheiben nicht enthalten, wenn du dies speziell timen möchtest, werden Unterlegscheiben benötigt. Hinweis: Dein Lauf benötigt möglicherweise eine Unterlegscheibe, wenn der Hersteller keine Gewindelockerung vorgesehen hat.