Eigenschaften
- Modell: 1200,1300,500,870,88
- Waffentyp: Maverick,Mossberg,Remington,Winchester
- Versandgewicht: 0,249kg
- Versandhöhe: 30mm
- Versandbreite: 51mm
- Versandlänge: 467mm
- UPC: 758152513007
Preise inkl. MwSt., zzgl. Versand
Artikel-Nr.: 019000004
Herst.-Nr.: SHS1300
758152513007 Geliefert mit einem kompletten Satz von Adaptern und Abstandshaltern für die Installation auf 12 Gauge Mossberg 500, Maverick 88, Remington 870 und Winchester 1200/1300 Pumpenschrotflinten. Einfach zu installieren, erfordert keine Modifikationen an der Feuerwaffe. Geformter Stahl mit verlängerten Kühlöffnungen schützt deine Hände vor Verbrennungen. Bietet eine sichere, rutschfeste Griffoberfläche sowie maximale Wärmeableitung. Einfach über den Lauf schieben und mit dem mitgelieferten Zubehör sichern. Die schwarze Oxidbeschichtung passt zu den meisten Schrotflintenoberflächen. Kein Büchsenmacherwissen erforderlich, um die meisten beliebten 12 Gauge Pumpenwaffen anzupassen.SPECS: Stahl, schwarze Oxidbeschichtung, matte Oberfläche. 13¾ (35cm) lang.
A good buy 25.01.2014
This was an easy install, it is not a custom piece built specific to any gun, it is built to fit every 870 ever made. Take your time and you won't damage the finish on your weapon or on the heat shield. The instructions are pretty clear and easily followed (I read them afterwards) no modification was required to my weapon (H&R Pardner Protector Pump) even though I installed an 870 wood stock and forearm and a +2 magazine extension. The heat shield does require a little patience for a good tight fit but looks good after installation. It is a great deal for quality and looks, especially because it it metal and cost the same as some synthetic models
1300 defender 05.03.2012
*this may not apply to all shotguns* The fit and finish of the product is unacceptable. During install the heat shield heavily scratches the barrel's finish. The receiver end of the shield does not grip the barrel well allowing it to move and produce wear on the barrel. The forward end, with the two screw holes, comes to you flared out and out of alignment. This neccesitates a lot of test fits and alterations which again damages the finish of the gun. A gunsmith might have better luck with it. Mine found its way into the dumpster.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.