FHD FLASH HIDERS These fit the plan B type mounts. This is an updated version that has larger wrench flats on the rear. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 30 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH H900 Atlas and Atlas XL Compatible Plan B Compatible Atlas XL Adapter No Overrun Black Nitride Finish (67 HRC Surface Hardness) Shims Not Included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.
FHD FLASH HIDERS Diese passen auf die Plan B Typ Halterungen. Dies ist eine aktualisierte Version mit größeren Schraubflächen hinten. Verwende immer einen Ausrichtungsstab, um sicherzustellen, dass das gesamte System korrekt eingerichtet ist. Stelle sicher, dass alle Oberflächen gereinigt sind und das Mündungsgerät fest angezogen und mit Rockset am Lauf befestigt ist. Die Verwendung auf einem Q Can kann deine Garantie ungültig machen, sei gewarnt. Ziehe das Mündungsgerät auf etwa 30 ft lbs an. Achte darauf, dass das Mündungsgerät rechtwinklig zur Schulter ist. Wenn du den Schalldämpfer auf das Mündungsgerät setzt, stelle sicher, dass die Gewinde und Konen sauber sind. Ziehe den Schalldämpfer auf 10 ft lbs an. Achte auf die Ausrichtung. Viel Spaß. Die Nitrieroberfläche führt zu einem engeren Sitz, daher ist es äußerst wichtig, dein Mündungsgerät ordnungsgemäß am Lauf anzuziehen und mit Rockset zu sichern. MERKMALE: 17-4 PH H900 Atlas und Atlas XL Kompatibel Plan B Kompatibel Atlas XL Adapter Kein Überlauf Schwarze Nitrieroberfläche (67 HRC Oberflächenhärte) Shimms nicht enthalten, wenn du dies speziell abstimmen möchtest, sind Shimms erforderlich. Hinweis: Dein Lauf benötigt möglicherweise einen Shim, wenn der Hersteller keinen Gewindeauslass angebracht hat.