Pre-machined aluminum pillars solve the difficult problem of bedding Ruger bolt action centerfire rifles. The front pillar is cut to match the 60 degree angle of the receiver screw; pre-notched with the correct contour and angles to fit against the bottom of the recoil lug and set square with the floorplate hinge. Fits all Ruger® 77 and M77® Mark II™ rifles except VT target models.
SPECS: Aluminum, natural finish. Front - .600" (15.2mm) long, .535" (13.6mm) dia. Rear - 1.145" (2.9cm) long, .535" (13.6mm) dia.
Vorgefertigte Aluminium-Pfeiler lösen das schwierige Problem der Bettung von Ruger Repetierbüchsen. Der vordere Pfeiler ist so zugeschnitten, dass er dem 60-Grad-Winkel der Verschraubung des Empfängers entspricht; vorgekerbt mit der richtigen Kontur und den richtigen Winkeln, um gegen die Unterseite des Rückstoßlugs zu passen und quadratisch mit dem Bodenplatten-Scharnier zu sein. Passt auf alle Ruger® 77 und M77® Mark II™ Gewehre, mit Ausnahme der VT-Zielmodelle.
SPECS: Aluminium, natürliche Oberfläche. Vorderseite - .600" (15.2mm) lang, .535" (13.6mm) Durchmesser. Rückseite - 1.145" (2.9cm) lang, .535" (13.6mm) Durchmesser.